Black Polymer Stock Set with Stainless Steel Heat Shield for Milled Receivers
U.S Made Black Polymer Stock Set for milled receivers comes with buttstock, upper and lower handguards, and a pistol grip.
- MSRP: $129.99
- SKU: SM1-BM
This part counts towards 922r compliance!
Made in the USA
California Proposition 65 Warning
U.S. Made Black Polymer Stock Set for milled receivers comes with buttstock, upper and lower handguards, and a pistol grip.
Buttstock is Intermediate length (0.75" longer than Warsaw length stocks), and includes cleaning kit compartment. Lower Handguard includes stainless steel heatshield.
Stocks and other furniture items may not be compatible with non-standard, non-mil-spec pattern AK rifles, or rifles manufactured by companies other than Arsenal. Fitting and/or adjustments may be required.
This USA manufactured part counts towards 922r compliance. See our 922r information page for more info on 922r compliance.
This Arsenal USA product is proudly manufactured in the United States of America in our state of the art manufacturing and design center located in Las Vegas, NV.
California Proposition 65
WARNING: None of the firearms manufactured or imported by Arsenal Inc. are manufactured or imported with the intent to be sold in CA. Nevertheless, be advised that some products sold on this website and/or manufactured by Arsenal Inc. can expose you to chemicals, including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
RonJul 15, 2021, 11:52:56 PMFit my 1997 mfg Arsenal SLR-95 (a D.I.G. import) absolutely perfect, no fitting or trimming necessary for all 4 parts, except on the installed lower tang piece (as recommended, below, for additional parts needed, as the thumbhole stock models only came with an upper tang). Luckily, my lower tang area had the slot already cut out, making this fairly easy. Converting to 922r compliant and dumping the old thumbhole stock and original Bulgi handguards and pistol grip, along with swapping out magazine floorplates and followers on my original E. German mags with U.S. mfg ones, for 5 total parts (all that's needed with a milled receiver AK). Just needed to install the lower tang (which you can install using the supplied rivets with the tang, if you also have the rivet install kit), OR, as I did, in order to alternately install my Ironwood Designs full walnut stock set (I have both, just to switch out when the mood strikes), I used M4 x .7 x 12mm socket-head (2.5mm allen key) pan-head screws along with matching lockwashers & nuts, to make switching out easy.